一、Introduction to equipment
　　YC-902 series of drum automatic aging machine - is our company for the lead-type aluminum electrolytic capacitor developed by a set of automatic boost aging, test sorting as one of the aging test equipment; the device using automatic preset boost Mode to automatically boost the high temperature aging, and to fully mechanized operation design, breaking the traditional aging equipment to be equipped with compressed air to run the limitations of the use of my company's latest research and development of the fifth generation of mechanical feed, to ensure that the machine feeding rate And the stability of the equipment, effectively improve the production efficiency, reduce unnecessary waste and labor costs.
1, the aging temperature: in the room temperature to 105 ℃ within the free set;
2, the device weight about 2500KG;
3, equipment size (area): 3600 (L) × 3000 (W) × 2100 (H) mm;
4, the total power of about 10KW equipment, the normal production of the average operating power ≤ 6KW

二、Adaptation scope：

1, the capacity test range: 0.01μF ~ 10000μF; test accuracy: ± 1%;
2, the loss angle: 0.001-0.999, the test accuracy: ± 1.0% ± 1 word;
3, the capacity test frequency: 120Hz, 1KHz can be set alone;
4, leakage current test range: 0.005μA-9999μA, test accuracy: ± 1% ± 0.2μA, two leakage test;
5, ESR test range (optional): 0.01mΩ-999kΩ, test accuracy of ± 1.0%, ESR test frequency: 1K / 10K / 20K / 100K Hz can be set alone;

三、working principle：
1, the product guide needle shaping and do the polarity detection, open circuit, short circuit detection; exclusion open, bending feet and short circuit products;
2, the product into the oven for high temperature by the linear power supply charging aging;
3, the product after the discharge cooling, the aging product is not detected, will exclude the aging products;
4, the product recharging about 40 seconds after the leakage current test;
5, the product after discharge capacity and loss of the angle test;
6, the product after the discharge by the "ESR" test (optional);
7, the test results are: high impedance, high capacity, low capacity, high loss, leakage large, good products, re-seized goods;
8, the machine using standard instrumentation test, which can effectively improve the accuracy of the parameters;
9, the device uses the latest generation of transport folder, which can effectively guarantee the service life;

四、Equipment performance：

1, the number of incoming and outgoing materials for the "test run" the actual number of minutes per minute, the error within ± 2;
2, the user can according to their own characteristics of the product stalls to select the product to ensure that the aging effect.
3, leakage test power and charging power and not aging Charging power and test power are used to establish an independent way to effectively ensure the accuracy of product testing.

五、Use environmental conditions：
11, using three-phase five-wire AC380V ± 5% 50Hz / 10KVA power supply;
2, the use of ambient temperature: room temperature;
3, the characteristics of the guarantee range: 23 ± 5 ℃, 45 ~ 75% RH;