一、Introduction to equipment
　　YC-805 series of high-speed low-pressure drum aging machine - is our company for aluminum electrolytic capacitors developed by a set of automatic boost aging, test sorting as one of the aging test equipment; the device using automatic preset boost mode The equipment to fully mechanized operation design, breaking the traditional aging equipment to be equipped with compressed air to run the limitations of the equipment to run more stable and simple, the use of equipment, The Chinese operation interface and a strong industrial control system, so that data collection, analysis is more simple, greatly improve production efficiency.
1, the aging temperature: in the room temperature to 105 ℃ within the free set;
2, the device weighs about 1500KG;
3,3600 mm (L) x 1858 mm (W) x 1600 mm (H);
4, the total power of about 10KW equipment, the normal production of the average operating power ≤ 6KW.

二、Adaptation scope：

Instrumentation indicators
1, the capacity of the test range: 0.01uF-19.9mF within the test accuracy of ± 0.5%;
2, the loss angle: 0.001-0.999, the test accuracy of ± 1.0%;
3, the capacity test frequency: 100Hz, 120Hz, 1KHz (3) can be set alone;
4, leakage current test range: 0.005μA-9999μA, test accuracy of ± 1.0%, two leakage test;
5, ESR test range: 0.01mΩ-999kΩ, test accuracy of ± 1.0%;
6, ESR test frequency: 1K, 10K, 20K, 50K, 100K can be set alone;
7, test data preservation: not less than 1 year, the user can be required according to the data into other storage devices for permanent preservation;
8, test reports: built-in software can export summary report data, compatible with Excel for the second analysis;

三、working principle：
1, the product guide needle shaping and do polarity detection, open circuit, short circuit and reverse polarity detection; exclude open circuit, short circuit, bending feet and anti-polar products;
2, the product into the oven for high temperature by 8 digital power boost charge aging;
3, the product after the discharge cooling, the aging product is not detected, will exclude the aging products;
4, the product recharging about 40 seconds after the leakage current test;
5, the product after discharge capacity and loss of the angle test;
6, (this function is optional function) product discharge and then "ESR" test;
7, the product by a special material extraction system out of the material, put an end to the fixture caused by the possibility of mixed products into the possibility; test results: good products, poor capacity,
High loss, large leakage, high impedance and heavy seized goods;

四、Equipment performance：

1, the user can according to their own characteristics of the product stalls to ensure that the aging effect of the product to select the stall requirements.
2, the test voltage: test charging voltage and short circuit test voltage are set up in an independent way, effectively guarantee the product testing accuracy.
五, the use of environmental conditions:
1, using three-phase five-wire AC380V ± 5% 50Hz / 10KVA power supply;
2, the use of ambient temperature: room temperature;
3, the characteristics of the guarantee range: 23 ± 5 ℃, 45 ~ 75% RH.